Forums > Kitesurfing Foiling

Anyone built one of these?

Reply
Created by Matt988 > 9 months ago, 17 Oct 2017
Matt988
WA, 154 posts
17 Oct 2017 2:50PM
Thumbs Up

www.clearwaterfoils.com

Built my first foil the last few weekends and it's turned out pretty similar to this. No idea if mine will work yet so thought one of these kits might be a good plan b if mine fails dramatically because there's no way I can afford a flash one

kit has YouTube instructional to go with it so hard to get it wrong.

tyro
TAS, 29 posts
19 Oct 2017 5:38PM
Thumbs Up

Hi Matt
I have one of the standard foils. I had no previous fibreglassing experience but with the videos James has on YouTube and some messing round I was able construct the foil. I've been out about six times now and I'm getting better each time.
I made my own "board" out of a project sheet of marine ply from Bunnings. The board is nowhere near as good as a proper surf board or some of the other project boards on this forum but it works for now.
I see that James has recently released a surf/sup foil as well. Its been a low cost way for me to get started foiling and its been interesting learning along the way. If you don't mind a bit of fibreglassing I don't think you'd have any issues with it if your current foil doesn't work out.

Matt988
WA, 154 posts
20 Oct 2017 7:18AM
Thumbs Up

Thanks for the reply mate. Good to know it works. I just bolted mine to a 10 buck ply skim board from toy world. Tested it the other day, it went up for a bit but my mast to base plate join gave in. Any tips on amount of glass to put on this joint to make it solid. Will try strengthen my one up but if it all gets to hard I might just get the kit. (Was my first go at proper fibre glassing too besides patching a tank like rough farmer)




tyro
TAS, 29 posts
20 Oct 2017 4:51PM
Thumbs Up

From memory I used between 10 and 14 layers per side of 4oz cloth to join the top plate and the mast.
I also used some microfibers to add strength to the join. www.westsystem.com/403-microfibers/

Matt988
WA, 154 posts
21 Oct 2017 7:43AM
Thumbs Up

Awesome thanks mate. Will load up the join this time and see what happens.

scubaste
WA, 210 posts
27 Oct 2017 6:49PM
Thumbs Up

Select to expand quote
Matt988 said..
Thanks for the reply mate. Good to know it works. I just bolted mine to a 10 buck ply skim board from toy world. Tested it the other day, it went up for a bit but my mast to base plate join gave in. Any tips on amount of glass to put on this joint to make it solid. Will try strengthen my one up but if it all gets to hard I might just get the kit. (Was my first go at proper fibre glassing too besides patching a tank like rough farmer)





Hay Matt
Get your self some carbon and epoxy resin west systems is good.
Twill , uni or biaxel carbon will do for the join try to get may be 5 layers per side.
Make sure you come down the mast maybe 200mm.
Then it wont break.

Also try putting some pressure over the carbon once wet an ready to go off, i used plastic over the wet carbon, the some thick sponge like gym mat then wood over the top, do this for both sides and clamp with quick grips or F clamps.

Good luck

Scuba



Subscribe
Reply

Forums > Kitesurfing Foiling


"Anyone built one of these?" started by Matt988